Section 06 DRIVE SYSTEM
Subsection 05 (BRAKE)
A35D08A
3
1 2
1. Banjo bolt
2. Sealing ring
3. Caliper bolt
Remove caliper.
Inspection
Check caliper for cracks or leakages. Replace if
necessary.
Installation
The installation is the reverse of the removal pro-
cedure.
NOTE: Bleed brake system before using the vehi-
cle.
BRAKE DISC
Removal
Apply parking brake.
Remove the cotter pin and discard it.
Unscrew the brake disc nut then remove it with
the spacer .
A35D09A
3
2
1
1. Cotter pin
2. Brake disc nut
3. Spacer
Unscrew caliper bolts no. 16 and place caliper out
of the way.
CAUTION: Do not let the caliper hang by the
hose and do not stretch or twist the hose.
Remove the brake disc no. 13.
Inspection
Before removing disc brake, measure its thick-
ness. The minimum thickness should be 4.5 mm
(.177 in).
If the brake disc is out of specification, replace it
by a new one.
CAUTION: The brake disc should never be ma-
chined.
Installation
The installation is the reverse of removal proce-
dure. However, pay attention to the following.
Install the brake disc with the collar toward chain-
case.
220 mmr2005-135
To Next Page
Loading...
