Section02ENGINE
Subsection 08 (BOTTOM END)
A32CB5A
A32CBWB
Remove all residue using pulley flange cleaner
(P/N 413 711 809).
Smear anti-seize lubricant (P/N 413 701 000) on
part of crankshaft where bearing fits.
A32CAUA
Crankshaft Bearing Preparation
Heat up the bearing(s) using bearing heater
(P/N 529 035 969). This will expand bearings
and ease installation. If required, put a suitable
plate or shim to avoid the direct contact between
integrated seal with the heating surface.
A32CB7A
CAUTION: Bearing(s) should not be heated to
more than 80°C(176°F). Do not heat bearing(s)
on direct flame, or with a heat gun or in an
oil bath. Inappropriate bearing(s) heating may
result in inner seals or cage failure.
Turnbearingseveraltimestoobtainanevenheat-
ing process.
70 mmr2005-118
To Next Page
Loading...
Need help?
General
