Solcon HRVS-DN series - Modbus Data and Register Mapping

135 • HRVS-DN Communication (ModBus Protocol)
_______________________________________________________________________________________________
16.7 Actual Data (3X References & 4X references)
Actual data includes measured values such as voltage, current and insulation resistance. It includes both
logic and statistical information. All parameters are word (two bytes) parameters. The protocol supports only
reading of these parameters.
Parameter # is "1 based". The actual parameter address is 1 lower than parameter #. For example the
address of parameter #1 is 0 (30000).
The parameters have double mapping, at the following 3x & 4x references:
Note: Function 4 should be used to read 3x references and function 3 to read 4x references.
Parameter # (3x) # (4x) Comment
Logic Status 1 257 Logic status of HRVS-DN. 1 indicates:
d15: HRVS-DN Trip.
d14: Motor Stopped.
d13: Motor in Soft Stop Process.
d12: Motor in Start Process.
d11: Motor is Running.
d10: Motor is running with Closed By_Pass.
d9: Up_To_Speed. Like d10 and I reduced (once) below
115% of FLA.
d8: Reserved.
d7: Dual_Adjust On.
d6..d0: Reserved.
Note: After bypass is closed, trip (d15) and running (d11),
can be ON together. See Trip_after_By-Pass setting
parameter at fault parameters page.
Hardwired inputs 2 258 Discrete Hardwired control inputs:
d15..d8: Reserved.
d7: External fault 2, Terminal 20.
d6: External Fault 1,Terminal 19.
d5: Reserved.
d4:Programmable Input , Terminal 8
Programming options:
0-D.Adj / 1- Slow.Speed / 2-Reset
d3: Programmable Input, Terminal 7
Programming options:
0-Test1 / 1-Reverse / 2-Reset
d2: Start Input. Terminal 6
d1: Soft Stop Input. Terminal 5
d0: Stop Input. Terminal 4
Relays 3 259 d0 - Immediate,d1- End Of Acc, d2 - Fault relay
Voltage 4 260 Line voltage, % of rated voltage.
I1_amp 5 261 Current of phase 1, Ampere.
I2_amp 6 262 Current of phase 2, Ampere.
I3_amp 7 263 Current of phase 3, Ampere.
Reserved 8 264
Dip_Switch 9 265 d15..d8: Reserved.
d7: Setting Lock - (right-most)
d6: Enlarged Setting Ranges
d5: Language Selection.
d4: Language Selection.
d3: Reserved - Must be set to Off.
d2: Generator Starting - Set to Off.
d1: Tacho feedback available (1).
d0: Min (off) / Max display pages- (left most)
Phase_Sequence 10 266 1: Correct Phase seq. 0 : Wrong Phase Seq.
Motor Insulation R 11 267 Motor Insulation Resistance [KOhm]
Reserved 12..14 268..270