Solcon HRVS-DN series - Control Module Main PCB and Optional Pcbs; Dip Switch Settings on the Main PCB; Switch # 1 - Display Modes

40 • Installation of IP00 (OEM Kit) in a Cabinet
_____________________________________________________________________________________________
6.3 Control Module Main PCB and Optional PCBs
Figure 15 - HRVS-DN Control Module
Remove top cover of the Control Module to access the main PCB, optional PCBs and dip switches.
6.4 Dip Switch Settings on the Main PCB
The dip switch has eight separate switches. It is located under the front cover of the Control Module.
No. Switch Function Switch Off Switch On
1
Display format Minimized Maximized
2
Tacho feedback Disabled Enabled
3
Must be off
- -
4
5
LCD language selection See tables below section
6.4.3 page 41.
6
7
Extended settings Disabled Enabled
8
Software lock Open Locked
6.4.1 Switch # 1 – Display Modes
Two display modes are available:
Maximized – display of all possible parameters.
Minimized – display of pre-selected parameters.
Setting switch # 1 to off will minimize the LCD displays.
Refer also to section
7.7 page 51.