85 • Packing, Storage, Handling and Assembly
_______________________________________________________________________________________________
Figure 24 – Cabinet Lifting Using 4 Lifting Cables. Top angle, A, Should be ≤60°
9.4 Soft starter’s Assembly Procedure:
Assembly procedure comprised of:
Mechanical assembly & Power and Control cables connection
When assembling the cabinet the following torque table should be applied for the mechanical and electrical
bolts closing:
Bolt size Torque
M4 1.5Nm
M5 2.5Nm
M6 4.5Nm
M8 10Nm
M10 20Nm
M12 40Nm
M16 80Nm
9.4.1 Mechanical Assembly
Four 22mm diameter holes located at the bottom frame of the cabinet as indicated in the
Figure 25.
Mount the cabinet in place and anchor it with 4 bolts.
Figure 25 – Anchor Bolts Holes Location on the Base of the Cabinet at Level 0mm.
To Next Page
Loading...
