60 • Control Keypad
_____________________________________________________________________________________________
7.8.3 Start Parameters – Page 2
START PARAMETERS
- **** -
Displays in MINIMIZED MODE and MAXIMIZED MODE
Display and Default
Values
Range Description
SOFT START CURVE
1 (STANDARD)
0 (BASIC)/
1 (STANDARD)/
2 !!/
3 !!/
4 !!/
5 (TORQUE)
Sets HRVS-DN’s SOFT START CURVE.
Refer to section
7.8.3.1 on page 65.
START TACHO. GAIN
0(MIN. GAIN)
0 (MIN. GAIN)/
1 !! /
2 !!/
3 !!/
4 !!/
5 !!/
1!! represents the 2nd level TACHO GAIN
2!! represents the 3rd level TACHO GAIN
5!! represents the 6th level TACHO GAIN.
Notes:
(1) This parameter will appear only if the optional PCB is
installed and dip switch # 2 is set to on. Refer to section
6.4.2
on page 41 for dip switch setting details.
(2) Tacho Feedback is operational in its basic form.
Additional curves except for the basic linear curve are
optional.
Consult the factory for the correct tacho selection and
mechanical installation.
To Next Page
Loading...
