Solcon HRVS-DN series User Manual

37 • Recommended Wiring Diagrams
_______________________________________________________________________________________________
5.12 Control Input #7
Notes:
 Switch D can be used as a Test
input/RESET/MULTI SOFT STOP (optional) as
programmed in I/O PROGRAMMING
PARAMETERS. Refer to section
7.8.7 page 73.
 MULTI SOFT STOP is applicable only when an
optional software for MULTI SOFT STOP is
installed.
 RESET function requires a momentary contact
to operate.
 Test function is a unique feature of the HRVS-
DN to test the operation of the firing system of
the HRVS-DN. Refer to section
14.3 page 121.
 Drawing shows Control Supply and Control
Input from the same source. Refer to section
5.2 and 5.3 for Control Supply and Control
Input from separate sources.
5.13 Control Input #8
Notes:
 Switch D can be used as a DUAL
ADJUST/RESET as programmed in I/O
PROGRAMMING PARAMETERS. Refer to
section
7.8.7 page 73. Refer also to section
5.9 page 34.
 RESET function requires a momentary contact
to operate.
 Drawing shows Control Supply and Control
Input from the same source. Refer to section
5.2 and 5.3 for Control Supply and Control
Input from separate sources.

Solcon HRVS-DN series Specifications

General

Brand	Solcon
Model	HRVS-DN series
Category	Controller
Language	English