Solcon HRVS-DN series User Manual

53 • Control Keypad
_______________________________________________________________________________________________
Appears only in
MAXIMIZED MODE
(1)
Appears only in
MAXIMIZED MODE
(1)
Appears only in
MAXIMIZED MODE
(1)
Appears when in
TEST/MAINTENANCE
(2)
FAULT PARAMETERS
- **** -
I/O PROGRAMMING
PARAMETERS
COMM.PARAMETERS
- **** -
STATISTICAL DATA
- **** -
TEST/MAINTENANCE
***OPTIONS***
Display and default
values
Display and default
values
Display and default
values
Display and default
values
Display and default
values
UV & PL AUTO RST
NO
PROG. INPUT #7
RESET
COMM. PROTOCOL
MODBUS
T SINCE LST STRT
NO DATA
RUN SELF TEST?
PUSH UP ARROW
UNDER CUR. RESET
OFF
PROG. INPUT #8
DUAL ADJUSTMENT
BAUD RATE
19200 (MODBUS)
LAST STRT PERIOD
NO DATA
PROGRAM VERSION
MVSTMB.GN-110808
BYPASS OPEN TRIP
ENABLE
FAULT RELAY TYPE
FAULT
PARITY CHECK
EVEN
LAST STRT MAX I
NO DATA
STORE ENABLE
DEFAULT PARAMET.
TRIP AFTER BYPASS
ENABLE
IMM. RELAY TYPE
IMMEDIATE
SERIAL LINK NO.
OFF
TOTAL RUN TIME
0 HOURS
RESET STATISTICS
BY-PASS AUTO RST
NO
RELAY ON DELAY
0 SEC.
S. LINK PAR. SAVE
DISABLE
TOTAL # OF START
0
VOLTAGE ADJUST.
15 % OF Vn
SET CURVE 0 FLT
ENABLE
RELAY OFF DELAY
0 SEC.
SER. LINK CONTROL
DISABLE
TOTAL ENERGY
0 KWH
CURRENT ADJUST
99% OF FLC
PWR ON & NO STRT
ENABLE
ANALOG OUTPUT
RELATIVE CURRENT
MODBUS TIME OUT
OFF
TOTAL R. ENERGY
0 KVARH
hh.mm mm.dd.yy
00:00 01/01/00
INSULATION ALARM
OFF
STORE ENABLE
I/O PROG.PARAM.
FRONT COM ADDRES
OFF
LAST TRIP
NO DATA
INSULATION TRIP
OFF
STORE ENABLE
COMM. PARAMETERS
TRIP CURRENT
0 % OF FLA
A
pplicable when
Modbus optional
PCB installed
Applicable when
profibus optional
PCB installed
PHASE SEQUENCE
POSITIVE
TOTAL # OF TRIPS
0
STORE ENABLE
FAULT PARAMETERS
Applicable when
DeviceNet optional
PCB installed
LAST 10 TRIPS
hh.mm mm.dd.yy
.
.
.
.
.
COMM. PROTOCOL
DVICENET
COMM. PROTOCOL
PROFIBUS
BAUD RATE
AUTO
BAUD RATE
AUTO
PARITY CHECK
AUTO
PARITY CHECK
AUTO
PREVIOUS TRIP -10
hh.mm mm.dd.yy
DEVICENET ID
SET MANUALLY
PROFI.NETWORK ID
126
S. LINK PAR. SAVE
DISABLE
S. LINK PAR. SAVE
DISABLE
SER. LINK CONTROL
DISABLE
SER. LINK CONTROL
DISABLE
MODBUS TIME OUT
OFF
MODBUS TIME OUT
OFF
FRONT COM ADDRES
OFF
FRONT COM ADDRES
OFF
STORE ENABLE
COMM. PARAMETERS
STORE ENABLE
COMM. PARAMETERS
(1)
- Refer to section 6.4.1 on page 40 for changing mode from MINIMIZED MODE to MAXIMIZED MODE.
(2)
- Refer to section 7.6 on page 48 for entering TEST/MAINTENANCE.

Solcon HRVS-DN series Specifications

General

Brand	Solcon
Model	HRVS-DN series
Category	Controller
Language	English