S Class 3 User’s Manual
Setup 1-3
FIG 1-1
1-1 EXAMPLE OF PROPERLY GROUNDED PLUG-SOCKET COMBINATION
The power supply detects the line voltage and switches automatically between 100V and 240V.
WARNING: The built-in power supply operates at hazardous voltages capable of
causing serious injury or death. Unplug the equipment when not used for an
extended period.
WARNING: Before changing the fuse(s), make sure that the cutter is completely
disconnected from its power source.
WARNING: For continued protection against risk of fire, replace only with fuse of
the same type and having the same electrical rating: T2AH 250V.
1.1.4 Electrical shock hazard
1.1.4.1 Grounding (“Earthing”)
WARNING: The wall sockets, into which the cutter is plugged-in, must be of the
grounded type. The grounded conductors, serving the wall socket, must be
properly connected to the ground.
For emergency access, the cutter should be installed near the socket-outlet for
easy access.
1.1.4.2 Operating voltage
To Next Page