Summa S3 Series - Table of Contents

Table of contents I
Table of Contents
1 Setup .............................................................................................................. 1-1
1.1.1 General .................................................................................................................. 1-1
1.1.2 Symbols used in the manual ................................................................................. 1-1
1.1.3 Safety precautions ................................................................................................ 1-2
1.1.4 Electrical shock hazard ......................................................................................... 1-3
1.1.4.1 Grounding (“Earthing”) ................................................................................. 1-3
1.1.4.2 Operating voltage .......................................................................................... 1-3
1.1.5 Warning labels on the machine ............................................................................. 1-4
1.1.6 Operating environment ......................................................................................... 1-5
1.2.1 The Cutter as viewed from the front ..................................................................... 1-6
1.2.2 The Cutter as viewed from the back ..................................................................... 1-7
1.2.3 Models (head types) .............................................................................................. 1-9
1.2.3.1 D models ........................................................................................................ 1-9
1.2.3.2 T models ........................................................................................................ 1-9
1.2.3.1 TC models ................................................................................................... 1-10
1.4.1 USB connection ................................................................................................... 1-12
1.4.1.1 Connecting the S Class 3 cutter to a PC, using a USB cable ...................... 1-12
1.4.1.2 Connecting the S Class 3 cutter to a Mac, using a USB cable .................... 1-13
1.4.2 Wired Ethernet connection .................................................................................. 1-13
1.4.2.1 Use static address ....................................................................................... 1-13
1.4.2.2 Use DHCP server .......................................................................................... 1-15
1.4.3 Wi-Fi (optional – region dependent) ................................................................... 1-16
1.4.3.1 Default setting ............................................................................................. 1-16
1.4.3.2 Fixed IP address setting ............................................................................. 1-17
1.5.1 Pinch roller positioning ....................................................................................... 1-19
1.5.2 How to Set the Pressure of the Outer Pinch Rollers ........................................... 1-20
1.5.3 How to Activate or Deactivate the Middle Pinch Roller(s) .................................. 1-21
1.5.4 Loading media ..................................................................................................... 1-22
1.6.1 Cutters with drag head ........................................................................................ 1-27
1.6.1.1 Drag Knife installation ................................................................................. 1-27
1.6.1.2 Pen installation ............................................................................................ 1-31
1.6.2 Cutters with tangential head ............................................................................... 1-32
1.6.2.1 Tangential knife installation ........................................................................ 1-32
1.6.2.2 Pen installation ............................................................................................ 1-36
1.6.3 Cutters with performance head .......................................................................... 1-37
1.6.3.1 Creasing tool installation ............................................................................ 1-37