Summa S3 Series - Configuration Menu

S Class 3 User’s Manual
Detailed operation 4-10
FIG 4-8
4-8 CONFIGURATION MENU
When connecting a cutter to Ethernet, several parameters need to be set in this menu. This is
explained in section 1.4.2.
Wi-Fi setup is explained in section 1.4.3.
There are four USB ports: USB port 1, USB port 2, USB port 3, USB port 4. Because of the
different USB ID’s, the computer can make a distinction between several cutters connected
(no more than four).
ATTENTION: The USB ID in the cutting software must be the same as the selected
USB ID in the cutter. Each time a new USB port is selected on the cutter and
connected to the computer for the first time, Windows will launch a wizard to install
a driver.
ATTENTION: This change becomes active after rebooting the cutter.
This submenu allows setting or changing the touchscreen interface language.
This submenu allows selecting whether the speed and length units are displayed in the metric
or imperial system.
Configuration
4.6 Configuration
4.6.1 Ethernet
4.6.2 Wi-Fi
4.6.3 USB Port
4.6.4 Language
4.6.5 Menu units