S Class 3 User’s Manual
Basic operation 2-4
The S Class 3 cutters can operate with a knife, pen, or creasing tool installed. Once a tool has been
changed, the tool parameters must be reset or checked. All tools have one parameter in common:
pressure. Each tool also has its own specific parameters. You can change tool parameters in the
current user or by changing the user itself (see section 2.5).
ATTENTION: The S Class 3 cutters will only perform according to the
specifications if a genuine Summa tool is installed. Do not replace with tools from
other manufacturers.
WARNING: Each keystroke can initiate an internal test or movement of the head
or media. Keep fingers and other body parts away from the cutting area. There are
hazardous moving parts present.
1. Power on the cutter and load the media (see section 1.5).
3. Tap a tool name to select it.
After the tool type is changed on-screen, the cutter will prompt the user to install the new tool.
NOTE: If no media is loaded, you can access the tool menu by tapping . After
the media is loaded, the cutter will prompt the user for a tool change if necessary
(see section 4.2.4).
Configuration 1
LAN 192.168.10.2
2.3 How to Set Tool Parameters
2.3.1 Setting the tool type
To Next Page