S Class 3 User’s Manual
Setup 1-36
The S Class 3 cutters can also function as a pen plotter when a pen is installed.
1. Turn the installed tool counterclockwise. The holder rises and can eventually be lifted out of the
tangential head. The nosepiece is situated underneath. Remove this part if it is mounted.
2. Gently insert the ballpoint pen holder into the tool shaft.
3. Turn the ballpoint pen clockwise all the way down.
4. The change of tool can either be done on the touch screen with Summa Cutter Control or with the
cutting software. Selecting the pen operation changes the pressure to pen pressure.
ATTENTION: The information on the touch panel shows the tool, currently selected
by the cutter. Make sure the cutter’s tool setting matches the actual tool in use.
To Next Page
Loading...
