Summa S3 Series - Page 5

Table of contents II
1.6.3.2 Setting up the second tool .......................................................................... 1-37
1.6.4 Replacement of the separation knife blade ........................................................ 1-39
2 Basic operation ........................................................................................... 2-1
2.1.1 Introduction........................................................................................................... 2-1
2.1.2 Basic operation ...................................................................................................... 2-2
2.1.2.1 Control buttons .............................................................................................. 2-2
2.1.2.2 Current settings ............................................................................................. 2-2
2.3.1 Setting the tool type .............................................................................................. 2-4
2.3.2 Changing tool pressure ......................................................................................... 2-5
2.3.3 Changing the drag knife offset .............................................................................. 2-6
2.3.4 Calibrating a tangential knife ................................................................................ 2-7
2.3.4.1 Calibrating ..................................................................................................... 2-7
2.3.4.2 Making corrections ........................................................................................ 2-9
2.7.1 Procedure ............................................................................................................ 2-15
2.7.2 Practical tips ........................................................................................................ 2-18
2.7.2.1 Physical knife depth tangential knife .......................................................... 2-18
2.7.2.2 Physical knife depth drag knife ................................................................... 2-19
2.7.2.3 Values of the FlexCut parameters ............................................................... 2-20
2.7.2.4 Material without backing ............................................................................. 2-21
3 OPOS.............................................................................................................. 3-1
3.2.1 Printing the graphic ............................................................................................... 3-2
3.2.2 Different OPOS alignment methods....................................................................... 3-3
3.2.3 Processing long jobs ............................................................................................. 3-4
3.3.1 Cutting multiple copies of a graphic on the same roll .......................................... 3-6
3.3.2 Cutting the same graphic on multiple media sheets ............................................ 3-8
3.3.3 OPOS Barcode ..................................................................................................... 3-10
3.3.3.1 Introduction ................................................................................................. 3-10
3.3.3.2 Initiating the barcode procedure ................................................................ 3-11
3.4.1 OPOS offset calibration ....................................................................................... 3-12
3.4.2 Calibrate media (OPOS) ...................................................................................... 3-13
3.5.1 Standard print and cut jobs ................................................................................ 3-15
3.5.2 Extra features OPOS camera ............................................................................... 3-15