S Class 3 User’s Manual
Setup 1-8
9. Pinch rollers: The pinch rollers clamp the media to the grit rollers to ensure accurate tracking.
Larger models have one or two pinch rollers in the middle to ensure that wide media stays flat in
the middle. These pinch rollers can be enabled/disabled, while of the outer pinch rollers the
pressure is adjustable. It is possible to install additional pinch rollers that will function the same
as any middle pinch rollers already provided.
10. Screws to secure the cutter base: All the screws must be properly secured before using the
cutter.
11. Tubes for the media basket: Tubes in the back and front hold the media basket. They can easily
be pulled outwards (open) to put the basket in its place.
12. Casters: The casters on the stand are equipped with locking brakes. When the cutter has been
moved to its new location, press the brakes with your foot to lock the casters.
13. Media support rollers: Rotating support rollers for the media roll.
14. Media basket to recover the cut material.
To Next Page
Loading...
