S Class 3 User’s Manual
Detailed operation 4-6
This submenu allows increasing throughput speed without increasing the overall speed of the
plotter by speeding up the drag motion. Cutting time is significantly reduced, especially when
cutting small, detailed designs. However, some thicker materials might not be cut properly
when this feature is activated.
This submenu allows enabling or disabling the internal segmentation function of the cutter.
Segmentation is used for several different applications. The most common are FlexCut and
long jobs with or without the roll-up option.
• Panelling: to set panelling on or off.
• Panel size: to set the panel size.
There are three options in this menu.
• Off: Default value. The vectors are not optimized. Choose this option when the intelligence
of the cutter driver is preferred.
• Directional: The vectors are optimized for the cutting direction (media movement). Choose
this option when the cutting pressure needs to be set relatively high (for example when
cutting through).
• Starting point: Optimizes the starting point for closed curves. Choose this option when the
curves do not close as they should.
To Next Page
Loading...
