Suzuki DF70A - Throttle Body Removal and Installation

Power Unit Mechanical: 1D-10
Throttle Body Removal and Installation
Z9J0111406007
Removal
1) Remove the Intake manifold assembly.
Refer to “Intake Manifold Removal and Installation”
(Page 1D-7).
2) Remove the flame arrester (1).
3) Remove the four bolts (2) securing throttle body to
intake manifold.
4) Remove the bolt (3) securing bracket (4).
Installation
Installation is reverse order of removal with special
attention to the following steps.
CAUTION
Do not reuse gaskets, always replace with
new one.
• Clean mating surface and install the seal ring (1).
• Install the throttle body (2), then securely tighten the
four throttle body bolts to specified torque.
Tightening torque
Throttle body bolt (a): 10 N·m (1.0 kgf-m, 7.2 lbf-
ft)
• Install the intake manifold.
Refer to “Intake Manifold Removal and Installation”
(Page 1D-7).
I9J011140120-01
I9J011140121-01
I9J011140122-01
I9J011140123-01
I9J011140124-01
http://SelfFixer.com