Power Trim and Tilt: 2B-13
Power Trim and Tilt Unit Removal and
Installation
Z9J0112206004
Removal
1) Remove the lower side cover.
Refer to “Lower Side Cover Removal and
Installation” in Section 2A (Page 2A-3).
2) Raise the engine to the full tilt up position and lower
the manual tilt lock levers (1).
WARNING
!
During the following procedures, the engine
must be firmly secured and its weight fully
supported. (See below)
3) Remove the tilt rod snap ring (2) and push the tilt
cylinder upper shaft pin (3) out.
4) Lower the tilt rod to the full down position and
disconnect the battery cable.
5) Remove the bolt (4) and cable clamp (5).
1
I9J011220060-01
I9J011220061-02
2
3
I9J011220062-01
I9J011220063-01
5
4
I9J011220064-01
To Next Page
Loading...
