Suzuki DF70A - Inspection of Fuel Vapor Separator Component Parts

Fuel System: 1G-20
2) Install the separator case and then tighten the
screws securely.
NOTE
When installing the separator case, align
suction hole “A” with hole “B” of separator
case.
Final assembly check
• Check to ensure that all removed parts are back in
place.
Inspection of Fuel Vapor Separator Component
Parts
Z9J0111706009
NOTE
If cracks, excessive wear or other damage is
found on any component, replace the
component.
Needle Valve / Valve Seat
Inspect the needle valve and valve seat for grooves,
other damage or dirt.
Replace or clean if necessary.
Float
Inspect the float for cracks or other damage.
Replace if necessary.
Filter
Inspect the pump suction filter for clogging or other
damage.
Replace or clean if necessary.
“A”
“B”
I9J011170047-01
I9J011170048-01
I9J011170049-01
I9J011170050-01
I9J011170051-01
http://SelfFixer.com