Power Unit Mechanical: 1D-20
Timing Chain, Chain Tensioner and Camshaft
Sprockets Removal and Installation
Z9J0111406011
Removal
1) Remove the oil pump.
Refer to “Oil Pump Removal and Installation” in
Section 1E (Page 1E-3).
2) Turn the crankshaft in its normal running direction
(LH direction) until the match mark “A” on the
crankshaft drive gear points to 12 o’clock position
(toward cylinder head).
CAUTION
When timing chain has been removed, never
turn crankshaft or camshaft.
Special tool
: 09911–49910 (Crankshaft holder)
3) Remove two bolts (1) and timing chain guide (2).
4) Remove the two bolts (3) and chain tensioner
adjuster (4).
5) Remove bolt (5) and timing chain tensioner (6).
6) Loosen and remove the bolt (7) securing IN.
camshaft timing sprocket to camshaft.
NOTE
• Intake sprocket bolt is LH thread.
• Hold camshaft by placing a wrench on the
hexagon area of the camshaft.
1. Engine normal running direction
1
“A”
I9J011140007-05
I9J011140166-01
I9J011140167-01
I9J011140168-01
I9J011140169-01
To Next Page
Loading...
