Suzuki DF70A - Lower Unit Related Items Inspection

3A-12 Right Hand Rotation Unit:
2) Place the installer shaft (A) (with pinion bearing on
end of installer shaft) into the gearcase.
3) Secure the plate (B) by tightening the bolt (C).
4) Thread the sliding hammer (E) into the top of the
installer shaft (A).
5) Drive the pinion bearing down into position by gently
striking the installer shaft (A) until the coupler
touches plate.
6) Assemble the lower unit. Refer to “Lower Unit
Assembly” (Page 3A-16).
Lower Unit Related Items Inspection
Z9J0113106024
WARNING
!
Wear safety glasses when using compressed
air.
NOTE
• If any component is worn excessively,
cracked, defective or damaged in any way,
it must be replaced.
• Thoroughly wash all metal components
with cleaning solvent and dry with
compressed air.
Gearcase
• Inspect the gearcase. Replace if cracked, damaged or
other abnormal conditions are noted.
• Visually check the pinion bearing. Replace bearing if
pitted, rough or other abnormal conditions are noted.
NOTE
For the removal and installation of pinion
bearing, refer to Pinion bearing removal and
installation.
1. Pinion bearing
(A)
(B)
(C)
(E)
I9J011310056-01
(D)
(A)
(C)
(B)
1
(E)
I9J011310006-04
I9J011310057-01
http://SelfFixer.com