Power Unit Mechanical: 1D-44
6) Mark cylinder number on pistons using quick dry
paint.
Push piston (with conrod) out through the top of
cylinder bore.
NOTE
• To prevent damage to piston rings,
decarbon top of cylinder bore wall before
removing piston.
• Reassemble each conrod cap to its
original position after removing piston
from bore.
7) Remove two compression rings (top and 2nd) and oil
ring from piston. Mark cylinder number on conrod
using quick dry paint.
8) Remove piston pin circlips (9) as shown.
9) Remove piston pin from conrod.
NOTE
Reassemble each piston, piston pin and
conrod in their original combination and
position.
10) Remove the bolts and exhaust cover (10) (if
necessary.).
I9J011140226-02
I9J011140227-01
9
I9J011140057-01
I9J011140058-01
I9J011140228-01
To Next Page
Loading...
