Engine Cooling System: 1F-15
Assembly
1) Install the oil seal with the special tool.
CAUTION
!
Replace the oil seal with a new one.
NOTE
The stamped mark on the oil seal should face
mechanical seal side.
Special tool
(A): 09913–70210 (Bearing installer set)
2) Apply a small quantity of the SUPER GREASE to the
oil seal lip.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
3) Install a new mechanical seal using a suitable size
socket wrench.
CAUTION
!
Replace the mechanical seal with a new one.
NOTE
On the new mechanical seal, the sealer “A”
has been applied.
4) Apply SUZUKI SUPER GREASE to the impeller
shaft.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
5) Install the impeller shaft and washer (1) to the water
pump body.
(A)
I718H1160056-01
I718H1160057-01
“A”
I718H1160058-01
I718H1160059-01
1
I718H1160017-01
To Next Page
Loading...
