1F-16 Engine Cooling System:
6) Install the rubber seal (2) into the impeller.
7) After wiping off the oily or greasy matter from the
mechanical seal ring (3), install it into the impeller.
NOTE
The paint marked side “B” of mechanical seal
ring faces the rubber seal.
8) Install the washer (4) and seal washer (5) onto the
impeller securing bolt.
NOTE
The metal side “C” of seal washer and the
curved side “D” of washer face the impeller
securing bolt head.
9) Install the impeller (6) and tighten the impeller
securing bolt to the specified torque.
Tightening torque
Impeller securing bolt (a): 8 N·m (0.8 kgf-m, 6.0
lb-ft)
10) Install a new O-ring (7) and apply engine coolant to
it.
CAUTION
!
Use a new O-ring to prevent engine coolant
leakage.
11) Fit the water pump case and tighten the water pump
case screws to the specified torque.
Tightening torque
Water pump case screw (b): 6 N·m (0.6 kgf-m,
4.5 lb-ft)
12) Tighten the water pump air vent bolt to the specified
torque.
CAUTION
!
Use a new gasket washer to prevent engine
coolant leakage.
Tightening torque
Water pump air vent bolt (c): 13 N·m (1.3 kgf-m,
9.5 lb-ft)
2
3
“B”
I718H1160018-01
5
“C”
“D”
4
I718H1160019-02
6
(a)
I718H1160021-02
7
I718H1160024-01
(b)
(b)
(c)
I718H1160025-01
To Next Page
Loading...
