Telit Wireless Solutions ME310G1 - ATS3 - Command Line Termination Character

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 131 of 1039 2021-09-23
Not Subject to NDA
3.2.3.4. ATS3 - Command Line Termination Character
The command manages the character configured as command line terminator.
ITU-T Recommendation V.25 ter
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
ATS3=[<char>]
Set command sets the value of the character either recognized by the
device as command line terminator and generated by the device as part of
the header, trailer, and terminator for result codes and information text,
along with S4 parameter.
Parameter:
Name
Type
Default
Description
<char>
integer
13
command line termination character
(decimal ASCII)
Value:
0÷127
:
command line termination character
The "previous" value of S3 is used to determine the command line
termination character for entering the command line containing
the S3 setting command. However, the result code issued shall use
the "new" value of S3 (as set during the processing of the
command line)
ATS3?