Telit Wireless Solutions ME310G1 - AT#JDR4 GCFG - LTE Jamming Detection Threshold Configuration

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 596 of 1039 2021-09-23
Not Subject to NDA
3.13.2. AT#JDR4GCFG - LTE Jamming Detection Threshold Configuration
The command configures the LTE Jamming Detection thresholds.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#JDR4GCFG=<P_RSRP_T4G>,<P_RSRQ_T4G>,<Initial_Delay>[,<Sampling_Nu
mber>
[,<P_RSSI_S4G>[,<UNUSED_4>[,<UNUSED_5>[,<UNUSED_6>[,<UNUSED_7>]]]]]]
Set command allows to configure the LTE Jamming Detection thresholds. After
configuration, use the #JDRENH2 command to enable/disable LTE jamming
detection and select reporting mode.
Parameters:
Name
Type
Default
Description
<P_RSRP_T4G>
integer
10
set the threshold of RSRP. The
threshold (RSRP_Thr) is calculated
as:
RSRP_Thr =
RSRP_Av*(1+(<P_RSRP_T4G>/100))
where RSRP_Av is the average of
the last 8 RSRP measures
Value:
0÷100
:
threshold of RSRP
<P_RSRQ_T4G>
integer
20
set the threshold of RSRQ. The
threshold (RSRQ_Thr) is calculated
as:
RSRQ_Thr= RSRQ_Av*(1-
(<P_RSRQ_T4G>/100))
where RSRQ_Av is the average of
the last 8 RSRQ measures
Value: