Telit Wireless Solutions ME310G1 - AT#PING - Send PING Request

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 711 of 1039 2021-09-23
Not Subject to NDA
3.15.30. AT#PING - Send PING Request
This command is used to send Ping Echo Request.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Other
No
-
2
AT#PING=<IPaddr>[,<retryNum>[,<len>[,<timeout>[,<ttl>[,<pdpId>]]]]]
Execution command is used to send Ping Echo Request messages and to
receive the corresponding Echo Reply. Before sending PING Request the
PDP context must be activated by #SGACT command.
Once the single Echo Reply message is received, a string like that is
displayed:
#PING: <replyId>,<Ip Address>,<replyTime>,<ttl>
Parameters:
Name
Type
Default
Description
<IPaddr>
string
-
address of the remote host, string type.
This parameter can be either:
- any valid IP address in the format:
"xxx.xxx.xxx.xxx"
- any host name to be solved with a
DNS query
<retryNum>
integer
4
the number of Ping Echo Request to
send
Value:
1÷64
:
Ping Echo Request number
<len>
integer
32
the length of Ping Echo Request
message
Value: