Telit Wireless Solutions ME310G1 - ATGPSP - GNSS Controller Power Management

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 961 of 1039 2021-09-23
Not Subject to NDA
3.25.2.3. AT$GPSP - GNSS Controller Power Management
This command powers on/off GNSS controller .
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Other
No
-
2
AT$GPSP=<status>
The set command manages the power-up/power-down of the GNSS
controller.
Parameter:
Name
Type
Default
Description
<status>
string
0
indicates the power status that has to be
set.
Values:
0
:
GNSS controller is powered down
1
:
GNSS controller is powered up
Power up clears GPS memory and then starts the GPS receiver.
GPS data cleaning is performed on the base of the current value of
the <reset_type> parameter (see $GPSR).
GPS operation mode is performed on the base of the current
values of $GPSSLSR configuration (see $GPSSLSR).
AT$GPSP?
The read command reports the current value of the <status> parameter, in
the format:
$GPSP: <status>