Telit Wireless Solutions ME310G1 - AT#SSLSEND - Send Data through a SSL Socket

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 816 of 1039 2021-09-23
Not Subject to NDA
3.19.8. AT#SSLSEND - Send Data through a SSL Socket
This command allows sending data through a secure socket.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT#SSLSEND=<SSId>[,<Timeout>]
Parameters:
Name
Type
Default
Description
<SSId>
integer
1
Secure Socket Identifier
Value:
1
:
only one socket is available
<Timeout>
integer
100
socket send timeout
Value:
1÷5000
:
timeout in 100 ms units
Additional info:
After command line is terminated with <CR>, the command returns
the following four-character sequence prompt:
<CR><LF><greater_than><space> (IRA 13, 10, 62, 32)
and waits for the data to be send.
79. to end the data editing and start the sending, enter Ctrl-Z
char (0x1A hex). The maximum number of bytes to send is
1023, trying to send more data will cause the data excess to
be discarded and lost.
80. to exit without sending the message, enter ESC char (0x1B
hex).