Telit Wireless Solutions ME310G1 - Page 817

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 817 of 1039 2021-09-23
Not Subject to NDA
If data are successfully sent, the command returns OK. If data
sending fails, an error code is reported.
If secure socket has not be enabled through #SSLEN command,
only test command can be used.
If timeout is not set for SSL connection, is used the timeout value
set by #SSLCFG.
Before sending data through the SSL connection, it must be
established using #SSLD.
AT#SSLSEND=?
Test command returns the range of supported values for all
the parameters.