Telit Wireless Solutions ME310G1 - ATS7 - Connection Completion Time-Out

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 136 of 1039 2021-09-23
Not Subject to NDA
3.2.3.7. ATS7 - Connection Completion Time-Out
This set command specifies the amount of time that the DCE shall allow between either
answering a call (automatically or by the ATA command) or completion of signaling of
call addressing information to network (dialing), and establishment of a connection with
the remote DCE. If no connection is established during this time, the DCE disconnects
from the line and returns a result code indicating the cause of the disconnection.
ITU-T Recommendation V.25 ter
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
ATS7=<tout>
Parameter:
Name
Type
Default
Description
<tout>
integer
60
defines time interval expressed in seconds
Value:
1÷255
:
available range
ATS7?
Read command returns the current value of S7 parameter.
The format of the numbers in output is always 3 digits, left-filled
with 0s.