Telit Wireless Solutions ME310G1 - AT+CMGW - Write Short Message to Memory

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 431 of 1039 2021-09-23
Not Subject to NDA
3.6.16. AT+CMGW - Write Short Message to Memory
The command is related to writing short messages.
3GPP TS 27.005
3GPP TS 23.040
3GPP TS 23.038
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT+CMGW
Execution command writes a new short message in the <memw>
memory storage (see +CPMS). It can have two syntax formats according
to the SMS format: PDU or Text mode (see +CMGF command). If short
message is successfully written the following URC is displayed:
+CMGW: <index>
Additional info:
In PDU mode the +CMGW command has the following syntax:
AT+CMGW=<length>[,<stat>]
After command line is terminated with <CR>, the module responds
sending a four-character sequence prompt:
<CR><LF><greater_than><space> (IRA 13, 10, 62, 32)
and waits for the specified number of bytes.
To write the message issue Ctrl-Z char (0x1A hex). To exit without
sending the message issue ESC char (0x1B hex).