Telit Wireless Solutions ME310G1 - AT+CMMS - more Message to Send

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 397 of 1039 2021-09-23
Not Subject to NDA
3.6.9. AT+CMMS - More Message to Send
Set command controls the continuity of SMS relay protocol link. When feature is enabled
(and supported by network) multiple messages can be sent much faster as link is kept
open.
3GPP TS 27.005
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT+CMMS=[<n>]
Parameter:
Name
Type
Default
Description
<n>
integer
0
enables/disables the
relay protocol link
continuity.
Values:
0
:
disable
1
:
keep enabled until the time between the response of the
latest message send command (+CMGS, +CMSS, etc.)
and the next send command exceeds 5 seconds, then
the link is closed and the parameter <n> is
automatically reset to 0
2
:
enable (if the time between the response of the latest
message send command and the next send command
exceeds 5 seconds, the link is closed but the parameter
<n> remains set to 2)
Entering AT+CMMS= returns OK but has no effect.