Telit Wireless Solutions ME310G1 - Page 597

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 597 of 1039 2021-09-23
Not Subject to NDA
0÷100
:
threshold of RSRQ
<Initial_Delay>
integer
500
Sets the delay in tens of ms from
power ON, to the beginning of the
RSSI samples collection
Value:
0÷1000
:
Value of Initial Delay
<Sampling_Number>
integer
30
Number of samples required to
validate the Jamming condition.
Value:
1÷200
:
Number of samples
<P_RSSI_S4G>
integer
-50
RSSI threshold level in dBm, above
which the Jamming condition is
detected.
Value:
-120÷-20
:
Value of RSSI Threshold
<UNUSED_4>
mixed
-
reserved for future use
<UNUSED_5>
mixed
-
reserved for future use
<UNUSED_6>
mixed
-
reserved for future use
<UNUSED_7>
mixed
-
reserved for future use
AT#JDR4GCFG?
Read command returns the current settings in the format:
#JDR4GCFG:
<P_RSRP_T4G>,<P_RSRQ_T4G>,>,<Initial_Delay>,<Sampling_Number>,
<P_RSSI_S4G>,0,0,0,0
Regardless the values used for parameters <UNUSED_4> ... <UNUSED_7>, the
read command returns always 0.