Telit Wireless Solutions ME310G1 - Page 349

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 349 of 1039 2021-09-23
Not Subject to NDA
0
:
SIMIN pin LOW means SIM inserted, HIGH
means SIM removed (for normal SIM holder).
1
:
SIMIN pin LOW means SIM removed, HIGH
means SIM inserted (for micro and nano SIM
holder)
SIMIN pin works only if #SIMDET is set to 2 (Automatic SIM
Detection).
If SIMIN pin is not connected to the SIM Holder, do not use
#SIMDET=2.
On ML865G1 and ME310G1 families there is no dedicated SIMIN pin
and AT#SIMDET=1 is the default value.
To use a TGPIO as SIMIN pin it has to be configured with:
AT#SIMINCFG= (stored in NVM) and AT#SIMDET=2 (stored in the
extended profile AT&P).
On ME910G1 family there is a dedicated SIMIN pin. So parameter
<GPIOPin> is meaningless and can be set only to 0
AT#SIMINCFG?
Read command reports the parameters values in the format:
#SIMINCFG: <GPIOPin>, <siminDetMode>
AT#SIMINCFG=?
Test command reports supported values of parameters <GPIOPin> and
<siminDetMode>.