Telit Wireless Solutions ME310G1 - Page 358

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 358 of 1039 2021-09-23
Not Subject to NDA
from user". In addition, the following URC
is sent on the AT interface. For parameter
meaning of the URC refer to Unsolicited
fields section.
#STN:<cmdTerminateValue>
Follows the <timeout> range.
Value:
1,2
:
timeout expressed in minutes
Additional info:
<mode>=3, the URC has the following reduced format: #STN: <cmdType>
<mode>=2, and <cmdType>=1 (REFRESH proactive command), the URC has the
following extended format:
#STN: 1,<refreshType>
<mode>=2, and <cmdType>=5 (SET UP EVENT LIST proactive command), the
URC has the following extended format:
#STN: 5[,<eventListMask>]
<mode>=2, and <cmdType>=16 (SET UP CALL proactive command), the URC has
the following extended format:
#STN: 16,<cmdDetails>,[<confirmationText>],<calledNumber>
<mode>=2, and one of the following proactive command:
<cmdType>=17 (SEND SS)
<cmdType>=18 (SEND USSD)
<cmdType>=19 (SEND SHORT MESSAGE)
<cmdType>=20 (SEND DTMF)