Telit Wireless Solutions ME310G1 - Page 360

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 360 of 1039 2021-09-23
Not Subject to NDA
<mode>=2, and <cmdType>=37 (SET UP MENU proactive command), the URC
has the following extended format:
the first line of output is:
#STN: 37,<cmdDetails>,<numOfItem>,<titleText><CR><LF>
one line follows for every item, repeated for <numOfItems>:
#STN: 37,<itemId>,<itemText>[,<nextActionId>]
<mode>=2, and <cmdType>=40 (SET UP IDLE MODE TEXT proactive command),
the URC has the following extended format:
#STN: 40[,<idleModeTextString>]
This Additional info section deals with the action initiated by the user (no
proactive commands activated by the SIM/USIM device).
If the call control or SMS control facility present in the SIM/USIM device is
activated, when the user application makes an outgoing call, or sends a SS or
USSD, or a SMS, the following #STN URC could be sent to indicate whether the
outgoing call has been accepted, rejected or modified by the SIM, or if the SMS
service center address or destination has been changed. For parameters
meaning refer to Unsolicited fields section.
#STN:
<cmdControlResponse>,<Result>[,<alphaIdentifier>[,<Number>[,<MODestAddr
>]]]
Unsolicited fields:
Name
Type
Description
<cmdTerminateValue>
integer
is defined as <cmdType> + terminate offset.
Terminate offset = 100
<cmdControlResponse>
integer
response of the SIM/USIM device
Values: