Telit Wireless Solutions ME310G1 - Page 559

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 559 of 1039 2021-09-23
Not Subject to NDA
Bands support varies depending on the product
2G support varies depending on the product
It is not possible to read RX power level during an ongoing TX
operation. If a read power level command is issued, transmission
is stopped.
For RL4G power level test, use a CW (continuous wave) signal with
a frequency offset equal to the 40% of the selected bandwidth.
e.g.
Band 1 - BW=1.4MHz - ARFCN 400 (downlink) - 2150.000MHz
CW signal must be set to 2150.560MHz
LTE signal can be also used.
e.g.
Settings: Band 1, BW=1.4MHz, ARFCN 400 (downlink)
corresponding to 2150.000MHz
LTE signal must be set to 2150.000MHz and BW must be set to
1.4MHz
The RL4G power level readout is valid in the -90dBm to -30dBm
range
The tolerance of the power value set with PL4G or read with RL4G
is +/-2dB
It is recommended to save CFUN=1 in NVM, before issuing
#TESTMODE
AT#TESTMODE?
Read command reports the currently selected <command> in the format:
#TESTMODE: <testModeStatus>