Telit Wireless Solutions ME310G1 - Page 574

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 574 of 1039 2021-09-23
Not Subject to NDA
AT#DGEN?
Read command reports the current settings of parameters, in the format:
#DGEN: <mode>,<GPIO>, <Trigger>, <Action>, <URC>, <text> , <text_format>,
<SMS_Num>,<cid>,<IPProtocol>,<IPAddr:Port>
At the very first boot no settings are present so read command will report a
default message:
#DGEN: 0
AT#DGEN=?
Test command reports the supported range of the parameters values.