Telit Wireless Solutions ME310G1 - Page 594

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 594 of 1039 2021-09-23
Not Subject to NDA
where RSSI_Avg is the average of
the last 50 RSSI measures.
Value:
0÷100
:
RSSI threshold values
<P_RSRQ_T4G>
integer
20
Set the threshold of RSRQ. The
threshold (RSRQ_Thr) is calculated
as
RSRQ_Thr = RSRQ_Avg*(1-
(<P_RSRQ_T4G>/100))
where RSRQ_Avg is the average of
the last 50 RSRQ measures.
Value:
0÷100
:
RSRQ threshold values
<unused>
integer
0
unused parameter
Value:
0
:
dummy value
Additional info:
<mode>=1
The jamming condition is reported on pin GPIO_02 (JDR):
47. GPIO_02 (JDR) = Low, Normal Operating Condition
48. GPIO_02 (JDR) = High, Jammed Condition
To have information on GPIO_02 pin, refer to document [1]. GPIO_02 pin
can be used also by other functionality, see #GPIO command.
<mode>=2
the jamming condition is reported with a single URC on serial line, in the
format: