Telit Wireless Solutions ME310G1 - Page 604

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 604 of 1039 2021-09-23
Not Subject to NDA
PDP. The address may be static
or dynamic:
49. for a static address, it will
be the one set by the
+CGDCONT command
when the context was
defined
50. for a dynamic address it
will be the one assigned
during the last PDP context
activation that used the
context definition referred
to by <cid>; <PDP_addr> is
omitted if none is available
AT+CGPADDR=?
Test command returns a list of defined <cid>.
AT#SGACT=3,1
#SGACT: xxx.yyy.zzz.www
OK
AT+CGPADDR=3
+CGPADDR: 3,"xxx.yyy.zzz.www"
OK
AT+CGPADDR=?
+CGPADDR: (3)
OK