Telit Wireless Solutions ME310G1 - Page 654

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 654 of 1039 2021-09-23
Not Subject to NDA
The checking if new data have
been received from serial port
is done with a granularity that
is directly related to #SCFG
<txTo> setting with a
maximum period of 1 sec.
Values:
0
:
select "old" method: start transmission
timer only first time if new data are
received from the serial port
1
:
select "new" method: restart
transmission timer when new data is
received from serial port
<abortConnAttempt>
integer
0
enable the abort of an ongoing
connection attempt started by
#SD command and before the
reception of the CONNECT
message (in online mode) or
OK message (in command
mode).
Values automatically saved in
NVM.
Values:
0
:
not possible to interrupt connection
attempt
1
:
it is possible to interrupt the connection
attempt (<connTo> set by #SCFG or DNS
resolution running if required) and give
back control to AT interface by reception
of a character. As soon as the control
given to the AT interface, the ERROR
message will be received on the interface
itself.
<unused_B>
integer
-
reserved for future use
<unused_C>
integer
-
reserved for future use