Telit Wireless Solutions ME310G1 - Page 684

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 684 of 1039 2021-09-23
Not Subject to NDA
Value:
1÷65535
:
host port number
<Rai>
integer
N/A
RAI (Release Assistance
Indication) configuration
Values:
1
:
Set RAI to: "No further uplink or downlink data
transmission subsequent to this transmission"
2
:
Set RAI to: "Only a single downlink data
transmission and no further uplink data
transmissions subsequent to this transmission"
RAI (Release Assistance Indication) is supported in NB-IoT only,
otherwise is ignored.
AT#SSENDUDPEXT=?
Test command reports the supported range of values for parameters <connId>,
<bytestosend>, <remoteIP>, <remotePort> and <Rai>.