Telit Wireless Solutions ME310G1 - Page 742

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 742 of 1039 2021-09-23
Not Subject to NDA
This command returns an ERROR result code if no FTP connection has
been opened yet.
Command closure should always be handled by application.
A timeout should be implemented by the application to avoid download
stall situations.
When verbose mode is enabled, i.e. <verbose> is set to 1, the '#'
character is printed on the AT command port for every 4096 bytes that
were written in FS
AT#FTPGETF=?
Test command returns the maximum length of <src_filename> and
<dest_filename> and the supported range of parameters <verbose> and
<overwrite_file>.