Telit Wireless Solutions ME310G1 - Page 812

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 812 of 1039 2021-09-23
Not Subject to NDA
AT#SSLD=?
Test command returns the range of supported values for all the parameters:
#SSLD: (1),(1-65535),,(0),(0,1),(1-5000)
See the following examples:
•
Start online mode:
AT#SSLD =1,8500,"84.94.194.21",0,1
OK
CONNECT
•
Start command mode:
AT#SSLD=1,8500,"84.94.194.21",1,1
OK
•
Configure correct PDP context with AT#SSLCFG command:
AT#SGACT=3,1
#SGACT: XX.XXX.XXX.XXX
OK
Note the second parameter of #SSLCFG
AT#SSLCFG=1,3,300,90,100,50,0,0,0,0
OK
AT#SSLD=1,<port>,"IP or URL",0,1
OK
CONNECT