Telit Wireless Solutions ME310G1 - Page 986

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 986 of 1039 2021-09-23
Not Subject to NDA
<enable>=2, in this case the AT interface port is dedicated to NMEA
sentences; it is not possible to send AT commands. Use the escape
sequence "+++" to return in command mode. GNSS data stream
format:
<NMEA SENTENCE 1><CR><LF>
...
<NMEA SENTENCE N><CR><LF>
...
The NMEA data stream format is the same as the one selected by
<enable>=1.
AT$GNSSNMEA?
Read command returns whether the unsolicited GNSS data stream is
currently enabled or not, along with the current NMEA mask
configuration, in the format:
$GNSSNMEA:<enable>,<nmea_mask>
AT$GNSSNMEA=?
Test command returns the supported range of values for parameters:
<enable>, (list of supported <nmea_mask> values).