ELECTRICAL
4203780 First Edition 4-91
4
Park Brake Switch
Removal and Installation
See Figure 4-71.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Disconnect the negative (–) battery cable at the
battery.
Figure 4-71
NOTE
Label all wires before disconnecting to ensure correct
installation.
3. Disconnect the wire connector.
4. Remove two nuts (4), lock washers (5), flat washers
(3) and screws (2).
5. Remove park brake switch (1).
Installation Note
Install the park brake switch by reversing the order of
removal.
Brake Pedal Switch
Removal and Installation
See Figure 4-72.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Disconnect the negative (–) battery cable at the
battery.
Figure 4-72
NOTE
Label all wires before disconnecting to ensure correct
installation.
3. Disconnect wire connector (2).
4. Remove two nuts (3), lock washers (4), flat washers
(5) and screws (6).
5. Remove brake pedal switch (1).
Installation Notes
• Install the brake pedal switch by reversing the order
of removal.
• Make sure switch is properly aligned to brake switch
activator plate.
• Adjust switch so that the brake pedal moves
approximately 0.5 in. (12.7 mm) before disengaging
switch and cruise control.
TN1992
1
3
4
2
5
TN1913
1
2
3 4 5 6
To Next Page
Loading...
Need help?
General
