4-98 4203780 First Edition
ELECTRICAL
4
Rocker Switches
See Figure 4-95.
Figure 4-95
This procedure applies to the following switches:
• Front Mow Enable Switch (4)
• Wing Mow Enable Switch (5)
• Cruise Control Switch (3)
• 4WD (Four Wheel Drive) Switch (2)
• Light Switch (1)
Removal and Installation
See Figure 4-96.
NOTE
Front mow enable switch shown.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Disconnect the battery negative (–) cable at the
battery.
3. Remove instrument panel. (See “Instrument Panel”
on page 4-110.)
Figure 4-96
NOTE
Label all wires before disconnecting to ensure correct
installation.
4. Disconnect wire connector (8).
5. Spread panel plug tab (6) on each side of rocker
switch (7) and pull rocker switch to remove.
Installation Notes
• Install rocker switch by reversing the order of
removal.
• See Figures 4-97 through 4-99.
Figure 4-97
• Arrow indicates rear of mower.
• Make sure front mow enable switch and cruise
control switch are installed as shown in Figure 4-97.
TN1936
3
1
2
4
5
8
7
TN1937
6
TN1965
To Next Page
Loading...
