Textron Jacobsen HR-5111 User Manual

4-92 4203780 First Edition
ELECTRICAL
4
Horn/Test Switch
Removal and Installation
See Figures 4-73 and 4-74.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Disconnect the battery negative (–) cable at the
battery.
3. Remove instrument panel. (See “Instrument Panel”
on page 4-110.)
Figure 4-73
Figure 4-74
4. Remove bezel nut (1).
NOTE
Label all wires before disconnecting to ensure correct
installation.
5. Disconnect wire terminals (2).
6. Remove horn/test switch (3).
Installation Notes
• Adjust jam nut (4) for proper switch height if
necessary.
• Install horn switch by reversing the order of removal.
Seat Switch
Removal and Installation
See Figures 4-75 through 4-77.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Disconnect the negative (–) battery cable at the
battery.
Figure 4-75
3. Tilt seat back (1) to forward position.
4. Cut cable ties (5).
NOTE
Label all wires before disconnecting to ensure correct
installation.
5. Disconnect wire connector (6).
6. Remove two screws (3).
7. Disengage lower seat back tabs (4) from seat back
support (2).
8. Push bottom of seat back (1) forward; lift and remove
seat back.
9. Lift rear of seat (7); slide forward and remove seat.
TN1936
1
TN1937
2
3
4
TN1987
1
5
4
4
5
2
6
7
3

Textron Jacobsen HR-5111 Specifications

General

Brand	Textron
Model	Jacobsen HR-5111
Category	Lawn Mower
Language	English