ELECTRICAL
4203780 First Edition 4-111
4
Volt Meter, Hour Meter, and Fuel
Gauge
See Figure 4-126.
Figure 4-126
This procedure applies to the following gauges:
• Volt Meter (1)
• Fuel Gauge (2)
• Hour Meter (3)
Removal and Installation
See Figure 4-127.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Disconnect the negative (–) battery cable at the
battery.
3. Remove instrument panel. (See “Instrument Panel”
on page 4-110.)
Figure 4-127
4. Remove nuts (5), lock washers (6), and bracket (4).
NOTE
Label all wires before disconnecting to ensure correct
installation.
5. Disconnect wire terminals (7).
6. Remove gauge.
Installation Note
Install the gauge by reversing the order of removal.
TN2030
1
2
3
TN2030
4
5 6
5 64
7
7
5 6
4
7
To Next Page
Loading...
